sketched_bend
Bends sheet metal along one sketch line on a flat face, setting angle, radius, side, and bend position.
Instructions
Bend sheet metal along the single line of a sketch on its flat face, toward the sketch's side (reverse bends the other way). SolidWorks chooses the side that stays; fixed_point in the result is on it. position: centerline (the line is the middle of the bend), inside, outside or bend_outside. Refused while flattened.
Tool call template
Replace each placeholder with a value matching the input schema. Only required parameters are included; add optional parameters as needed.
{
"id": 1,
"jsonrpc": "2.0",
"method": "tools/call",
"params": {
"arguments": {
"sketch": "<sketch>",
"angle": "<angle>"
},
"name": "sketched_bend"
}
}Input Schema
| Name | Required | Description | Default |
|---|---|---|---|
| unit | No | mm, cm, m, inch or ft | |
| angle | Yes | Bend angle in degrees (1-179) | |
| radius | No | Bend radius (default: the part's) | |
| sketch | Yes | Name of a sketch with one line, on a flat face of the sheet | |
| reverse | No | Bend away from the sketch's side | |
| position | No | Where the bend sits on the line | centerline |