select_edges
Select body edges by points, face points, or edge IDs, then filter by type, axis, or loop to prepare accurate fillets and chamfers in SOLIDWORKS.
Instructions
Select body edges by geometry (the view does not matter), ready for fillet_edges / chamfer_edges. Choose by points (the edge nearest each point), face_points (one point = every edge bordering that face; two points = the edge the two faces share) or edge_ids from list_edges (refused if the geometry changed since it listed them; points are safer). With none of these, a filter alone selects from all edges. The filters edge_type, parallel_to and loop narrow the choice.
Tool call template
This tool declares no required parameters. Add optional parameters from the input schema as needed.
{
"id": 1,
"jsonrpc": "2.0",
"method": "tools/call",
"params": {
"arguments": {},
"name": "select_edges"
}
}Input Schema
| Name | Required | Description | Default |
|---|---|---|---|
| loop | No | With one face point: the face outline (outer), its hole edges (inner) or both | all |
| unit | No | mm, cm, m, inch or ft | |
| append | No | Add to the current selection instead of replacing it | |
| points | No | Model points on or near the edges to select (one edge per point) | |
| edge_ids | No | Edge ids from list_edges | |
| edge_type | No | Keep only edges of this type | |
| tolerance | No | How far a point may be from its edge (default 0.5 mm) | |
| face_points | No | One point inside a face = all its edges; two points on two faces = their shared edge | |
| parallel_to | No | Keep only straight edges parallel to this model axis |