edit_mate
Change a mate's distance, angle, limit, or alignment, rebuild the assembly, reject changes other mates block, and report the updated mate and moved components.
Instructions
Change an existing mate: value for a new distance or angle, flip_dimension to put the distance / angle on the other side, flip_alignment to swap aligned and anti-aligned (or alignment to set it directly). The assembly is rebuilt; a change the other mates do not allow is undone and refused. Reports the mate as read back and which components moved.
Tool call template
Replace each placeholder with a value matching the input schema. Only required parameters are included; add optional parameters as needed.
{
"id": 1,
"jsonrpc": "2.0",
"method": "tools/call",
"params": {
"arguments": {
"name": "<name>"
},
"name": "edit_mate"
}
}Input Schema
| Name | Required | Description | Default |
|---|---|---|---|
| name | Yes | Mate name from list_mates, e.g. 'Distance1' | |
| unit | No | Unit of the distance (mm, cm, m, inch or ft) | |
| value | No | New distance (in unit) for a distance mate, or degrees for an angle mate | |
| maximum | No | New largest distance of a limit distance mate | |
| minimum | No | New smallest distance of a limit distance mate | |
| alignment | No | Set the alignment outright instead of flipping it | |
| flip_alignment | No | Switch between aligned and anti-aligned | |
| flip_dimension | No | Put the distance / angle on the other side |