Trigger setup and control
scope_triggerConfigure and control an oscilloscope's edge trigger by setting source, level, slope, sweep, coupling, holdoff, and noise rejection, then force, arm, or check trigger status.
Instructions
Configure and control the edge trigger.
Tool call template
Replace each placeholder with a value matching the input schema. Only required parameters are included; add optional parameters as needed.
{
"id": 1,
"jsonrpc": "2.0",
"method": "tools/call",
"params": {
"arguments": {
"operation": "<operation>"
},
"name": "scope_trigger"
}
}Input Schema
| Name | Required | Description | Default |
|---|---|---|---|
| level | No | Trigger level in volts | |
| slope | No | ||
| sweep | No | auto: free-runs without trigger | normal: waits for a trigger | |
| source | No | 1-4/'ch1'..'ch4', 'd0'..'d7', 'ext', 'line' or 'wgen' | |
| wait_s | No | arm: seconds to wait for the trigger (0 = don't wait) | |
| holdoff | No | Holdoff in seconds (40 ns - 10 s) | |
| coupling | No | ||
| hf_reject | No | High-frequency reject (50 kHz LPF) | |
| operation | Yes | set: configure edge trigger | get | force: force a trigger now | arm: single-shot arm (:SINGle) | status: running? triggered since last check? | |
| noise_reject | No | Noise reject (increased hysteresis) |
Output Schema
| Name | Required | Description | Default |
|---|---|---|---|
No arguments | |||