econtest-bench-mcp
This server does not currently have a deployable release on Glama. Follow the repository's setup instructions to install and configure it for your MCP client, including any required credentials and local dependencies.
电赛信号题统一 MCP
econtest-bench-mcp 是面向电赛低压信号题的 USB/VISA MCP Server 与 Agent Skill,当前版本为 0.3.0。
支持设备:
SIGLENT SDS2000X Plus 系列示波器;实机验证 SDS2502X Plus。
SIGLENT SDG6000X/SDG6000X-E 系列信号发生器;实机验证 SDG6032X-E。
能力与边界
仅支持 USBTMC + NI-VISA/PyVISA;不支持 LAN、无线、Telnet 或 WebControl。
信号源支持 SINE、SQUARE、RAMP、PULSE、扫频,以及基波加 1~2 个整数次谐波;输出软上限为 3 Vpp,且要求
|Offset| + Vpp/2 <= 3.3 V。谐波功能使用原生
HARM,以各分量 Vpp 之和作保守包络;已在 SDG6032X-E6.01.01.38R3T7完成 50 Ω 样本 001 实机写入、回读和人工示波器验收,不上传WVDT任意波数据,其他固件仍需单独验证。支持示波器配置、RUN/STOP/SINGLE、原生测量、有界 BYTE 波形、当前面板 PNG 截图和证据化完整回路。
幅度、Vpp、频率验收优先使用
scope_measure_simple的原生读数;波形和 PNG 用于证据与诊断。scope_screenshot已在 SDS2502X Plus5.0.0.1.6.2R5实机验证:读取 PNG、校验 CRC/尺寸,并在截图后复核身份。旧固件和其他型号需单独验证。所有写操作执行身份校验、
*OPC?、回读与证据记录;完整回路在结束或失败时尝试关闭信号源并确认示波器 STOP。
实机截图示例见 screen.png。
Related MCP server: dso2d15-mcp
MCP 工具
类别 | 工具 |
发现与状态 |
|
信号源 |
|
示波器 |
|
工作流与产物 |
|
文档
安全要点
软件不能验证接地、隔离、探头位置、额定值或 DUT 上电状态;这些由操作者负责。
不得将 BNC 地端或示波器地夹连接到非隔离高侧节点。
输出 ON 必须明确确认目标和负载;通信丢失时不得声称输出已关闭。
不提供任意 SCPI、
*RST、固件更新、网络配置或仪器文件系统操作。
所有证据写入 artifacts/runs/<UTC时间>_<run_id>/。使用 skill/econtest-signal-bench/scripts/validate_evidence.py 校验 manifest、文件大小和 SHA-256。
鸣谢
本项目在架构、设备驱动和安全证据设计上参考了以下开源项目:
Tool Schema Changelog
Recent tool additions, removals, and schema changes observed during successful MCP inspections.
Loading tool schema changelog…
This server cannot be deployed
Maintenance
Related MCP Connectors
QuLab MCP remote server (Streamable HTTP) for computational science and lab tools.
Remote MCP server for deterministic educational practice-assessment score conversions.
An MCP server that measures MCP client behaviour and converts EBCDIC to ASCII, which nobody needs.
Related MCP Servers
- AlicenseAqualityBmaintenanceAn MCP server that enables AI assistants to control Siglent SDS oscilloscopes over a local network using SCPI commands. It allows users to measure signals, configure channel and acquisition settings, and capture waveforms or screenshots through natural language.12929 npm12MIT
- AlicenseNot gradedqualityDmaintenanceMCP server for controlling Hantek DSO2D15 and other DSO2000-family oscilloscopes via USB and SCPI, enabling waveform acquisition, measurements, and screen captures.1MIT
- AlicenseAqualityBmaintenanceMCP server that lets AI assistants control Siglent SDG waveform generators over a local network using natural language, supporting signal generation, modulation, sweep, burst, and arbitrary waveforms.20514 npmMIT
- AlicenseNot gradedqualityDmaintenanceAn MCP server that connects AI assistants to the Owon DS1102 oscilloscope, enabling waveform capture, measurement retrieval, and remote control of scope settings.GPL 3.0