Enables MCP clients to control a Nordic PPK2 for power profiling: configure source/measurement modes, set voltage, power DUT, measure current/power/energy, and capture logic channels.
Enables MCP clients to list, inspect, probe, capture, and analyze current measurements from the Nordic Power Profiler Kit II, returning aggregates and file paths rather than raw samples.
Enables control of the Multicomp Pro MP711134 bench power supply and multimeter over USB serial, allowing an LLM agent to power-cycle boards, measure current profiles during boot, run custom voltage/current profiles, and wait for conditions without polling.
Enables LLMs like Claude to interact with PicoScope oscilloscopes for signal acquisition, measurement, and analysis. Supports device management, data capture, triggering, and signal generation through natural language commands.