Skip to main content
Glama
AutoCAD MCP

AutoCAD MCP

draw_circle

Draws a circle in AutoCAD using center coordinates (cx, cy) and radius r, with an optional layer.

Instructions

Окружность: центр (cx,cy), радиус r.

Tool call template

Replace each placeholder with a value matching the input schema. Only required parameters are included; add optional parameters as needed.

{
  "id": 1,
  "jsonrpc": "2.0",
  "method": "tools/call",
  "params": {
    "arguments": {
      "cx": "<cx>",
      "cy": "<cy>",
      "r": "<r>"
    },
    "name": "draw_circle"
  }
}

Input Schema

NameRequiredDescriptionDefault
rYes
cxYes
cyYes
layerNo0

Output Schema

NameRequiredDescriptionDefault
resultYes

Schema Changelog

Changes observed during successful MCP inspections.

  1. First observedv0.3.0

TDQS

C2.6/5.0
Behavior2/5

Does the description disclose side effects, auth requirements, rate limits, or destructive behavior?

With no annotations, the description carries the full burden of behavioral disclosure, and it discloses almost nothing: no mention that it mutates the drawing, adds an entity to a layer, or what happens on invalid inputs. The presence of a 'layer' argument is never explained, so an agent cannot know which layer the circle lands on or what the default '0' means in practice.

Agents need to know what a tool does to the world before calling it. Descriptions should go beyond structured annotations to explain consequences.

Conciseness3/5

Is the description appropriately sized, front-loaded, and free of redundancy?

The definition is a single short fragment with zero filler and the essential geometry is front-loaded. However, its brevity reflects under-specification rather than efficient compression, since key parameters are simply omitted.

Shorter descriptions cost fewer tokens and are easier for agents to parse. Every sentence should earn its place.

Completeness2/5

Given the tool's complexity, does the description cover enough for an agent to succeed on first attempt?

An output schema exists, so return values need not be explained, but the definition leaves major gaps for a mutating 4-parameter drawing tool with no annotations: layer targeting, units, and interaction with existing entities are all absent. For a parametric CAD primitive, this is below adequate.

Complex tools with many parameters or behaviors need more documentation. Simple tools need less. This dimension scales expectations accordingly.

Parameters2/5

Does the description clarify parameter syntax, constraints, interactions, or defaults beyond what the schema provides?

Schema description coverage is 0%, so the description must compensate; it only restates the mapping of cx/cy to the center and r to the radius, adding no units, coordinate-system, or range information. The fourth parameter, 'layer', is never mentioned at all, leaving a quarter of the inputs explained only by a bare title and a default value.

Input schemas describe structure but not intent. Descriptions should explain non-obvious parameter relationships and valid value ranges.

Purpose4/5

Does the description clearly state what the tool does and how it differs from similar tools?

The description names the concrete operation and resource ('Окружность', i.e. draw a circle) and lists the geometric inputs (center cx,cy and radius r), so an agent can tell what entity is produced. It does not differentiate from siblings such as draw_arc or draw_ellipse, so it stops short of a 5.

Agents choose between tools based on descriptions. A clear purpose with a specific verb and resource helps agents select the right tool.

Usage Guidelines2/5

Does the description explain when to use this tool, when not to, or what alternatives exist?

There is no guidance on when to use this versus draw_arc, draw_ellipse, or a polyline approximation, and no prerequisites or constraints are stated. The only clue is the geometric definition itself, which implies usage but never states it.

Agents often have multiple tools that could apply. Explicit usage guidance like "use X instead of Y when Z" prevents misuse.