Turn a village, town, region, country or postcode in Europe into coordinates.

Also reads plus codes and map links. A region, country or postcode comes back with bbox (west, south, east, north) and served (yes, part or no: whether reports are made there). Street addresses are found in Norway, Belgium and Denmark. Elsewhere an address is reduced to the settlement it names and marked approximate. When nothing is found, message says what to add.

Whether RuralCheck can analyse this point, and how finely the ground is measured.

served: false means analyse_plot will refuse the point, and the answer says why.

Every check a report can run: its name, what it answers, roughly how long it takes, and whether the free plan runs it (free). Pass names from here to analyse_plot.

Analyse a plot of rural land in Europe and return the result of each check.

Checks a chosen one depends on run too and are returned with it. Most answers take a few seconds. If one runs longer than this call waits, the answer carries an id to pass to get_report.

An account can start one new report a minute, so name every check needed in one call. Fetching a report with get_report does not count.

Show the attribution lines to whoever reads the results: the data licences require it.

Fetch a report analyse_plot started, by its id. Waits if it is still running.

The public sample: a real full report for 4 ha of land at Trémolat in the Dordogne valley, France.

Use it to see what each check returns before asking for a report of your own.

Send an estate agent's listings to RuralCheck. Professional plan.

Each listing becomes a saved plot with a full report and a share link the agent can put in the listing. Reports run one after another on the server, about half a minute each, and wait for anyone using the site, so this returns at once with the upload's id. Follow it with get_listing_upload. Up to 100 listings run from one upload. A listing that is not run comes back with the reason, for example no position, outside the area covered, or past the limit. A listing already saved with a current report is not run again. One upload runs at a time on an account.

An upload's progress: for each listing its status, its share link once its report is done, or the reason it was not run. status is "done" when nothing is left to run.

The account's listing uploads, newest first, with how far each has got.

The plots this account keeps, newest first, with the key figure of each check, and the account's folders.

Plots in the Trash are left out unless in_trash is true. Each one there has a deleted_after date. It can be restored until then.

One kept plot with its report, as it was when it was kept.

report.current is false when the checks have changed since. Running analyse_plot again and keeping the result brings it up to date.

Keep a finished report in My plots.

Only a report that ran every check of the account's plan can be kept, so call analyse_plot without naming checks first. Keeping the same point again replaces its report, keeps its name and note, and takes it out of the Trash if it was there.

Rename a kept plot or replace its note. A plot in the Trash must be restored first.

Put a kept plot in a folder, or take it out of the one it is in.

Move a kept plot to the Trash.

It can be restored with restore_plot until its deleted_after date, 30 days on, and is then removed for good. Nothing through this server deletes a plot at once.

Take a plot out of the Trash, back into its folder if that still exists.

The account's folders, each with how many plots are in it.

Make a folder for kept plots. Each name can be used once, whatever the case.

Rename a folder.

Delete a folder. Its plots stay in My plots, in no folder.