Set a point to a fixed value
set_pointSets a simulator point to a fixed engineering value and stops any signal on that point so the value persists until changed; returns the updated point.
Instructions
Set one point to a fixed engineering value (the simulator applies the point's scale and data type). Any signal running on that point is stopped, so the value stays until changed again. Use set_signal for a value that changes over time and write_registers to write raw words at an address. Returns the point with its new value. Fails if the device or point does not exist.
Tool call template
Replace each placeholder with a value matching the input schema. Only required parameters are included; add optional parameters as needed.
{
"id": 1,
"jsonrpc": "2.0",
"method": "tools/call",
"params": {
"arguments": {
"device_id": "<device_id>",
"point": "<point>",
"value": "<value>"
},
"name": "set_point"
}
}Input Schema
| Name | Required | Description | Default |
|---|---|---|---|
| point | Yes | Name of an existing point on that device (see get_device or read_points). | |
| value | Yes | New engineering value. For bool points use 0 or 1. | |
| device_id | Yes | Id of a running device, as returned by create_device, clone_device or list_devices. |